Explosion-proof LED floodlight 100W LED Flood Light LED explosion proof LED floodlight projection lamp explosion proof LED floodlight 100W LED projection lamp 40w 50w 60w 70w 80w 100w 120w 150WLED _LED proof lights Explosion-proof floodlight LED Floodlight Lamp LED Flood Light Explosion, also known as LED explosion proof floodlight, LED projection lamp explosion. LED Explosion floodlight control through the built microchip, existing two types of products, the use of power-type chip combination, more stable performance, large single powerful product structure, can achieve very high power, large distances can be cast light. Applications: ● for a variety of flammable and explosive places and outdoor work, construction site and equipment, facilities and other places for a large area flood lighting. Structural features: ● excellent explosion-proof design, ensure safe use in a variety of flammable and explosive places. ● Housing protection rating to IP66, waterproof performance, can resist the impact of surging waves. ● overall structure design, lightweight, good impact resistance, can be reliable and stable work under vibration environments. ● Precise optical design, with specular high purity aluminum reflector, to achieve a large range of floodlighting, lighting efficiency up to 77%, higher than the industry average of 30%. ● supporting the electrical system design optimization, so that the lamp up to 90% electrical efficiency, power factor of 0.9. ● Efficient goods into the solid state LED light source, high luminous efficiency, long life, not only effectively improve work efficiency, but also reduces the amount of maintenance products. ● overall structure, can adjust the lighting angle wide range, with a special electrical maintenance cover, easy installation and maintenance. ● Advanced shell anti-corrosion coating, corrosion level reached WF2, to ensure that lighting does not corrode in the salt spray and other harsh environments. Note Folding 1. Regular eliminate dust and dirt on the housing explosion-proof lighting, light fixtures improve efficiency and thermal performance. Cleaning methods according to shell lamps protection, the use of water (a symbol on the lamp shade above) or wipe with a damp cloth. When clean water, cut off the power. Do not use a dry cloth to wipe the lamp plastic housing (transparent member), to prevent static electricity. 2. Check whether the highly transparent piece traces the impact of foreign objects, loose safety net, sealing off corrosion. If so, should stop using, and timely maintenance and replacement. 3. The light damage should be lights, notice replaced, so the light source can not start leaving the ballast and other electrical components in an abnormal state long. Lighting the lamp vessel used in wet environments 4. if water should be promptly removed, replace the seal member, make sure the shell protective properties. 5. When the cover is opened, it should be a warning sign requirements, after opening the lid off the power. 6. After opening the cover should be the way to check the flameproof joint surface is intact, the rubber seal is hard or sticky, wire insulation is made of green and carbonation, whether insulating parts and electrical components have deformed and scorch. These problems are found, repairs should be replaced. 7. Close the cover with a damp cloth before application (not too wet) wipe light fixtures back light transparent parts, in order to improve light efficiency lamps. In flameproof combined surface coated with a thin layer should 204-1 replacement anti-rust oil, should pay attention to the seals for closing lid sealing function in the original position. 8. lamps sealed sections should regularly disassemble and open.