DGS10/127L (A) LED roadway lights

DGS10/127L (A) LED roadway lights for the occasion
◆ Suitable for coal mine methane and coal dust explosive gas mixtures occasions. Coal transportation roadway, the shaft bottom, electrical and mechanical caverns, back to the wind tunnel, coal preparation plant lighting.

DGS10/127L (A) Overview of LED roadway lights:
◆ LED roadway lights using the most advanced green light high power LED as a light source and carefully designed and manufactured in accordance with national standards GB386.1.2.3-2000 explosive atmospheres Electrical equipment "required

The proof mark for ExdI the lighting of the implementation of standard products inspected by the coal industry Shanghai Electric Explosion Inspection Station, the safety standard national mine safety certification mark issued product safety signs.

DGS10/127L (A) LED roadway lights Features:
◆ mine flameproof LED roadway lights adopts the international advanced electronic integrated circuits, wide voltage design, the operating voltage range, 85V to 265V voltage can work properly. Light source straight

Flow, low voltage power supply, no flicker and electromagnetic interference, no red (purple), radiation, fluorescent lamps, mercury vapor and other pollutants, in line with the EU's future lighting production standards, lighting for safety, health

Environmental effect is obvious.
◆ low power consumption, under the same illumination, the power consumption of 1/10 of incandescent lamps, fluorescent lamps 1/2, with significant energy savings.
◆ reasonable structure, beautiful appearance, small size, light weight, explosion-proof, shock and vibration resistance, resistance to heat sealing, maintenance-free.
◆ lighting power, lighting and wiring separate unique design of the cavity, making the whole lamp is not only good looks, easy to install, but also improves the lamp explosion-proof, shock, anti-vibration, heat

Performance indicators fully consistent with the mine with explosion-proof lighting, state and industry standards.

DGS10/127L (A) LED roadway lights installation methods:
① First, combined with the actual needs of the job site to determine the lighting installation location and means of corresponding length Φ8 ~ Φ14 mm three-core cable, and then prepared according to the distance of the lamps to the power contacts.

② Open the lighting of the superstructure side set screws, lighting cable Loosen compression nut of the introduction of the mouth, open the cover, the power cable through the compression nut is introduced into the internal wiring terminals, according to plans

Show the connection fixed, and then tighten the cable clamp nut and lighting superstructure.
③ Replace the lamp Unscrew the lamp ring Hexagon tight set screw and unscrew the lamp ring and transparent components and light body, and put a new lamp, the lamps can be installed in the opposite direction.