Flameproof / increased safety / compact explosion-proof lights (BAD83 factory explosion-proof lights)

Second, the scope of application:

¤ Applicable to explosive gas atmospheres - Zone 1, Zone 2 places;

¤ Applicable to combustible dust Area 20, 21 and Zone 22 places;

¤ In II A, II B, II Class C explosive gas atmospheres;

¤ Applies to T1 ~ T6 temperature classification of group;

¤ Higher, humid place for the protection requirements;

¤ Widely used in oil exploration, oil refining, chemical, military, and other hazardous environments and offshore oil platforms, oil tankers and other places.

Flameproof / increased safety / compact explosion-proof lights (BAD83 factory explosion-proof lights)

Third, the product features:

¤ The shell is made ??of aluminum alloy die-casting molding, surface high pressure electrostatic spray;

¤ Transparent tempered glass cover, design Prism glare;

¤ Protection network using high-quality carbon steel galvanized surface spray, double anti-corrosion;

¤ Threaded flameproof and the Mouth of explosion-proof structure, reliable performance, explosion-proof;

¤ The structural design of the high degree of protection, the use of high temperature, anti-aging silicone rubber seals;

¤ Set between the light source chamber and the electrical cavity air convection Kong, the use of air flow, effectively distributing the heat of the light source chamber to ensure the long life of the lamps;

¤ High purity aluminum reflector, anodized, high efficiency reflector;

¤ Humane terminals, easily effective and reliable connection of wires and terminals;

¤ Light sources with long life, high color rendering, high light efficiency discharge lamp (induction lamp);

¤ Wide input voltage, the output luminous flux constant;

¤ A special high-frequency generator, constant power, with open and short circuit protection;

¤ High power factor cos φ ≥ 0.90;

¤ By the state authorities, in line with the requirements of EMC standards;

¤ Steel pipe wiring G3 / 4 ";

Flameproof / increased safety / compact explosion-proof lights (BAD83 factory explosion-proof lights)

Fourth, the technical parameters:

¤ Implementation of standards: to GB3836.1, and GB3836.2, GB12476.1, IEC6007, IEC6007-1, IEC61241-0, IEC61241-1, EN60079-0 and EN60079-1, EN61241-0, EN61241-1

¤ Explosion-proof mark: Exd II CT6/DIP ? A20TA, T6 ?

¤ Rated voltage: AC180V ~ AC 260V ??? 50 / 60HZ

¤ Rated power: 40W 50W 85W 135W 165W

¤ Of protection: IP66

¤ The anticorrosive Level: WF1 ?? * WF2

¤ The introduction of devices: G3 / 4 "to introduce specifications, suitable for φ is 10mm to φ is 14mm cable

¤ Terminals: ≤ 2.5mm ² conductors and reliable connection ^??

¤ Installation: ceiling (X), the wall 30 ° (b1), the wall 90 ° (b2), pendant (g), barricade-type (h), flange type (f) of

Flameproof / increased safety / compact explosion-proof lights (BAD83 factory explosion-proof lights)

V. Quality Assurance:

¤ This product is in strict accordance with the of IS09001: 2000 international quality management system standards for quality control to ensure product quality is higher than the national standards fully meet the design requirements, since the purchase of three years, any failure by the Company (non-human failure) maintenance-free product under normal use.