Explosion proof lights range lights for explosion proof LED lamp manufacturers refrigerator with lights BAD808-RLED proof lights ◎ BAD808-RLED proof lights applicable ● 1 and Zone 2 IIA, IIB class T1 ~ T6 group explosive atmosphere, as factories or places lighting purposes. BAD808-RLED explosion-proof lights lamp can work reliably under the following conditions ● altitude does not exceed 2000m; ● ambient operating temperature is -20 ~ + 40 ℃ :; ● ambient air relative humidity less than 98% (when the temperature is at + 25 ℃ ); ● applies to a Zone 2, Class II T1 ~ T6 group explosive atmosphere; in the absence of significant local ● shake and shock vibration;; ● No damage in metals and insulating properties of gases and vapors in place ● Pollution Level 3; ● Installation Category II class. ◎ BAD808-RLED proof lights structural characteristics ● Product Standard: GB3836.1 ~ 2-2010, Q / HH 001-2011. ● This product is aluminum alloy, after high-speed shot blasting surface electrostatic spray, waterproof, dustproof, anti-corrosion and other functions. Stainless steel exposed fasteners, transparent pieces with glass anti-high-energy impact, lighting for the structure of the mouth flameproof joints only, but the source chamber and wiring chamber, drive chamber separated, easy installation and maintenance, and reliable electrical performance; high quality aluminum reflector cover, improve the efficiency of the lamp. ● The lamp has a grounding screw inside and outside the shell, the user uses the product should be grounded. ◎ BAD808-RLED proof lamp technical parameters proof grade: Exd II B T6 Gb Rated voltage: 220VAC 50Hz Rated power: 20W 30W 40W 50W 60W Light Source Type: LED Protection: IP65 corrosion grade: WF2 Installation: boom-type (G) Wall 30 ℃ (b1) wall 90 ℃ (b2) Ceiling (x) guardrail formula (f) Law-column (h) ◎ BAD808-RLED proof lights before use and maintenance ● LED lights installed on the nameplate should be checked Basic technical data is listed realistic conditions of use. ● There equivalent diameter φ10mm ~ φ14mm cable entry through the rubber seals on the introduction of connected terminals, with the introduction of cable clamping nut pressed, so that the seal and prevents pull off. ● Before use, check the wiring is correct, the fastening screws (bolts) are secured to the housing. Cable ground wire should be reliable grounding. ● When servicing "non-electrified openings" and may not bump, damage the rubber gasket. ● repair, if found to introduce seals, gaskets and other devices are aging, should be replaced in order to ensure protection performance. ◎ BAD808-RLED proof lights transport storage ● LED lights in the transport process, should prevent shock or strong vibration, and should have measures to prevent rain and snow. ● LED lights should be stored in air circulation, no dripping water and liquid invasion, ambient temperature does not exceed + 40 ℃, not lower than -25 ℃, air relative humidity less than 98% (+ 25 ℃) warehouse. ● In the storage of LED lights surrounding environment should not contain metal and damage the insulation of corrosive gases. BAD808-RLED proof lights ● This product is in strict accordance with the IS09001: 2000 international quality management system standards for quality control to ensure product quality is higher than the national standards fully meet the design requirements, since the purchase of three years, any failure (non-human failure under normal use ) free maintenance by the Company.